LaserLiner DigiLevel - Page 9

DigiLevel Laser
GB
09
KEYPAD
1. Angle reference value setting
2. ON / OFF switch
3. Acoustic signal on/off
4. Memory retrieval
5. Unit of measurement selection
(° degrees / % / IN/FT)
6. MEMORY function
DISPLAY
7. Slope direction
8. Slope angle
9. Current memory position
(M1 – M9)
10. Battery charge
DigiLevel Laser
11. Vertical vial
12. Horizontal vial
13. Magnets
14. Measuring surface
15. Line laser
REAR
16. Battery compartment
Acoustic signal:
• The acoustic signal can be switched on or off with button (3).
• When the angle of slope stands at 0°, 45°, 90° or the most recently
stored value, this is indicated by an acoustic signal.
NOTE: When working with a changed angle reference value,
the acoustic signal is activated on reaching the new reference value
(0°, 45°, 90° display).
1
3
2
6
5
4
97 108
14
16
12
11
15
13
Man_DigiLevel_Laser_Rev0712_DE_PL.indd 9 16.07.12 15:20