FixView Camera
07
Safety instructions
Using artificial, optical emission (OStrV)
LED outlet
– The device works with LEDs of risk group RG 0 (exempt,
no risk) in accordance with the latest versions of applicable
standards relating to photobiological safety
(EN 62471:2008-09ff / IEC/TR 62471:2006-07ff).
– When used for the intended purpose and under reasonably
foreseeable conditions, the accessible radiation of the LEDs
is safe for the human eye and skin.
Safety instructions
Dealing with electromagnetic radiation
– The measuring device complies with electromagnetic
compatibility regulations and limit values in accordance
with EMC-Directive 2014/30/EU.
– Local operating restrictions – for example, in hospitals,
aircraft, petrol stations or in the vicinity of people with
pacemakers – may apply. Electronic devices can potentially
cause hazards or interference or be subject to hazards
or interference.
Information on maintenance and care
Clean all components with a damp cloth and do not use
cleaning agents, scouring agents and solvents. Store the
device in a clean and dry place.
– The unit is not suitable for taking measurements close
to dangerous voltages. Therefore always make sure
that conductive parts are at zero potential when carrying
out measurements in the vicinity of electrical systems.
Safe isolation from the power supply and precautions
to prevent systems being switched on again must be
ensured by implementing suitable measures.
EN
To Next Page
Loading...
