Need help?Do you have a question about the LaserLiner MultiMeter-Pocket and is the answer not in the manual?
Describes compliance with EMC directives and local use restrictions.
The rotary switch used to select the measurement function.
The switch used to activate the built-in flashlight.
Mechanism for changing between different measurement functions.
The Liquid Crystal Display for showing measurement values.
The sensor element for detecting voltage without contact.
Indicator for the non-contact voltage detection function.
The designated place to store the test probes.
Function to freeze the currently displayed measurement.
The red (+) and black (-) measurement probes.
The detachable probes used for measurements.
Describes compliance with EMC directives and local use restrictions.
The rotary switch used to select the measurement function.
The switch used to activate the built-in flashlight.
Mechanism for changing between different measurement functions.
The Liquid Crystal Display for showing measurement values.
The sensor element for detecting voltage without contact.
Indicator for the non-contact voltage detection function.
The designated place to store the test probes.
Function to freeze the currently displayed measurement.
The red (+) and black (-) measurement probes.
The detachable probes used for measurements.
General| Type | Digital Multimeter |
|---|---|
| Display | LCD |
| Resistance Range | 0.1Ω to 20MΩ |
| Diode Test | Yes |
| Continuity Test | Yes |
| Safety Category | CAT III 600V |
| Power Source | 2 x AAA Batteries |
| Measurement Functions | Resistance, Diode |
| Current Range | 10A |
| Power Supply | 2 x AAA Batteries |
To Next Page
