LaserLiner SmartVision-Laser Manual

12
LASER LASER LASER LASER
LASER LASER LASER LASER LASER
3 Slope mode
Do not release transport safety, push ON/OFF switch (4) to
the right. Select and switch on the laser with the selection
button. Sloping planes can now be measured. This mode
cannot be used to perform horizontal or vertical levelling
as the laser lines are no longer aligned automatically.
The LED lights constantly red.
The transport restraint must be released for horizontal
and vertical levelling. The LED shows a permanent
green light. The laser lines flash and the LED lights red
as soon as the device is outside the automatic levelling
range of 5°. Position the device such that it is within
the levelling range. The LED switches back to green
and the laser lines stop flashing (steady light).
!
2 Horizontal and vertical levelling
Release the transport restraint, move the ON/OFF switch (4)
to the left. The laser cross will appear. The laser lines can be
switched individually with the selection button.
When transporting always switch off all lasers, secure
pendulum and push the ON/OFF switch (4) to the right.
!
EN

LaserLiner SmartVision-Laser Specifications

General

Brand	LaserLiner
Model	SmartVision-Laser
Category	Measuring Instruments
Language	English