LAVAZZA FLAVIA CREATION 600 - Setting Up Your Brewer; Step-by-Step Setup Procedure

USER GUIDE | 13
Switch o the water supply, connect the in-line water lter, then
connect the brewer to the water line as illustrated (Fig1). Connect the
supplied power cord into the back of the brewer and screw the buer
bar onto the threaded stud (Fig1).
Plug the brewer into the mains using the supplied power cable (Fig2).
Switch on using ON/OFF switch at back (Fig3).
Follow the on-screen instructions for priming and setting the brewer up.
Input all required elds on the screen, such as Oce Size, Industry,
and Brewer location. (Fig4).
Ensure to accept the End User Licensing Agreement on the screen.
After the on-screen guided setup, ensure the brewer is connected.
1
2
3
4
5
6
SETTING UP
YOUR BREWER
(Fig1)
(Fig3)
(Fig2)
(Fig4)
(If you are also installing the optional modules, see page 10, please refer
to user guide supplied with those products before setting up brewer).