14
FLUSHING THE BREWER
On rst set up of the brewer or if the hot tanks have been drained
and the machine needs to be re-primed, water will need to be ushed
through internal workings. After switching on the brewer at install,
please refer to the on-screen instructions in order to do a ush. You can
also perform a ush at any point from the Operator menu. Consider
ushing the brewer if it has been switched o for 5 days or more.
The basic steps of ushing the brewer are as follows:
Remove the drip tray.
Partly slide out the Freshpack
bin far enough to capture the
water, which will be dispensed as
illustrated.
Follow the on-screen instructions
in order to complete the ush.
After the ush, empty any water
from the Freshpack bin, clean the
bin, fully install it back into the
brewer and replace the drip tray.
The brewer will then require 2
minutes to heat the water before
it can produce its rst hot drink.
Please note that the volume of
the rst 5 drinks may be variable
as the brewer calibrates itself.
1
2
3
4
5
To Next Page
Loading...
