Need help?Do you have a question about the Lavry LavryBlue LE-4496 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Sample Rates | 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz |
| Bit Depth | 24-bit |
| Digital I/O | AES/EBU, S/PDIF |
| Clock Input | Word Clock |
| Clock Output | Word Clock |
| Simultaneous A/D Channels | 2 |
| Simultaneous D/A Channels | 2 |
| Type | AD/DA Converter |
| Analog Inputs | 2 x XLR |
| Analog Outputs | 2 x XLR |
| Dynamic Range | 110 dB |
| Frequency Response | 20 Hz - 20 kHz |
| Power Supply | External |
Master Sync controls AD converter clocks for phase coherence.
DA converters clock externally, jitter elimination via CrystalLock.
M-SYNC supplies clock for M•AD-824, controls A-to-D clocking modes.
Details internal and external clock operations, sample rate switch settings.
Switch positions for setting sample rates (44.1, 48, 88.2, 96 kHz).
How to lock M-SYNC to external Word Clock or AES signals.
Explains proper Word Clock signal termination for the SYNC IN connector.
Converts analog audio to AES digital, receives clock from M•SYNC.
How to navigate and use the SET/SELECT switch for functions and parameters.
Guide to selecting word length (16, 20, 24 bits) using front panel switches.
Analog peak limiter before ADC to protect against overloads.
Emulates tape saturation, raises signal levels below -12dBFS by 6dB.
Dither, ABC-1, ABC-2 for word length reduction and noise shaping.
Explains the digital level meters, MAX lamps, and signal level indications.
Enables holding and indicating the highest peak level, resettable via front panel.
Expands meter range around a reference level for detailed input level monitoring.
How modules operate in master or slave mode, copying parameters.
Lists external front panel settings and internal settings.
Details the function of each position of the DIP switch (Master/Slave, Polarity, ABC).
Explains jumper settings for balanced audio input and soft saturation threshold.
Specifies the dynamic range of the converter.
Specifies the Total Harmonic Distortion plus Noise for various levels.
Specifies the common mode rejection ratio.
Converts digital audio to analog audio, clocks to incoming digital signal.
Explains the function of the LOCK MODE switch (CrystalLock, Narrow, Wide).
Describes how sampling rate and lock status are indicated on the module.
Allows inversion of signal polarity for analog outputs.
Details the front-panel volume controls for analog output adjustment.
Mentions internal settings accessible by opening the unit.
Describes jumper settings for balanced and unbalanced analog output configurations.
Explains the 4-position DIP switch for clock settings.
Describes the dual-channel microphone preamplifier module.
Details internal settings for configuring balanced/unbalanced outputs and phantom power.
Lists technical specs for MicPre module: gain, noise, inputs/outputs.
To Next Page