How long does it mow for?
The L10 can mow for durations of 4, 6, 8 and 10 hours. The mowing duration selected
should depend on the time of year and the size of the lawn.
For example, in spring it is advised to select a higher cutting height and longer duration,
gradually reducing the height of cut until the grass is uniformly short. This will cause less
stress to the lawn and give the best battery performance.
Once the grass has reached the desired length, the duration can be shortened to 4-6
hours for “maintenance cutting”, depending on the size of the lawn. For larger lawns, a
longer duration may still be needed to maintain a desirable result.
Can it be programmed for specific times?
The L10 can be programmed to start at a specific time each day. The start time can be
changed by turning the mower off, then on again via the switch underneath the mower.
The L10 will mow every day, for the duration selected using the keypad.
Please note that turning the L10 off via the switch underneath the mower for any reason
will alter the start time. The new start time will be the time at which the mower is
turned on again and the start operation is performed.
Is it noisy?
The L10 is extremely quiet at only 62dB. Enjoy a snooze while the L10 takes care of the
lawn!
Do I need to bury the wire?
Although the boundary wire can be buried if desired, it’s not necessarily recommended.
Cutting the grass very short where the boundary wire is to be laid is usually enough, and
after a few weeks the grass will have grown over the boundary wire, making it practically
invisible. Laying the boundary without burying it also makes it easier to make changes
and repairs later.
Where can I buy extra blades and other spare parts?
Replacement blades and other spares such as boundary wire, boundary wire repair kits
and our patented labour-saving device, the Lawnmaster Peg Driver, can be purchased
from cleva-uk.com.
To Next Page
