EasyManua.ls Logo

LawnMaster NPTBL31AB - Troubleshooting

LawnMaster NPTBL31AB
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The engine does not
start.
The on/o󰀨 switch is
switched to the stop
position “O”.
Make sure the on/o󰀨 switch is in the “I” ON
position when starting the product.
The battery is not
secure.
Insert the battery correctly. Ensure the battery is
fully charged.
No spark.
Clean or replace the spark plug. Refer to the
Spark Plug Replacement section in this manual.
No fuel.
Check that there is su󰀩cient fuel in the fuel tank.
Push the primer bulb until the bulb is full of fuel.
If the bulb does not ll, the primary fuel delivery
system is blocked. Contact a qualied service
dealer. If the primer bulb lls, the engine may be
ooded, proceed to the next item.
The engine is
ooded.
Remove the spark plug referring to the Spark
Plug Replacement section in this manual. Press
the start button 5 to 10 times. Then leave the
blower still with the spark plug removed for about
30 minutes. After 30 minutes, replace the spark
plug referring to the Spark Plug Replacement
section. Then re-start the engine. If the engine
still does not start, contact a qualied service
dealer.
The air lter is
blocked.
Clean the air lter. Refer to Cleaning the Air Filter
section in this manual.
If your blower does not appear to operate properly, follow the instructions below. If this does not
solve the problem, please contact your local repair agent. For replacement parts, please visit www.
cleva-europe.com.
Before proceeding, shut o󰀨 the engine, wait for all moving parts to stop, and remove the battery
pack. Wait until the surfaces cool down. Failure to follow these instructions can result in serious
personal injury or property damage.
WARNING

Other manuals for LawnMaster NPTBL31AB

Related product manuals