LeakAlertor
®
6000 User’s Guide
www.leakalertor.com
tel: 610.594.2191 |toll free: 877.532.5253
LA6KUGPC67 JUN17A 15 E. Uwchlan Ave Ste 412 | Exton, PA 19341
Installing Your LeakAlertor – This is SO easy!
1) Remove tank lid.
2) Place the LeakAlertor over
the edge of the tank.
3) Replace tank lid.
4) Pull battery tab.
(Gently press the unit against the tank while pulling
the tab straight down to remove.)
5) That’s It!! You’re Done!
I Just Pulled the Battery Tab…Now What Happens?
➢ When the battery tab was pulled, you probably noticed that the LEDs (the colored
lights) flashed and the unit beeped – the LeakAlertor now needs some time to get
ready to work on your toilet.
➢ For the next hour, you will see the GREEN LED flashing – this is normal. Feel free to
use your toilet during the time – you won’t upset the LeakAlertor.
➢ When the RED, YELLOW, and GREEN LEDs begin to flash together, go ahead and flush
the toilet. Don’t worry if you can’t get to flushing the toilet right away – the
LeakAlertor will patiently wait for you.
➢ The LeakAlertor is now working and will let you know if there is a problem.
How do I know if I have a problem with my toilet?
Every time you flush the toilet, watch, and listen to the LeakAlertor!
*See the LA 6000 Support Page on the website for more detailed information.
To Next Page
Need help?
General
