LeapFrog Yum 2-3 Deluxe Breakfast Set - Getting Started: Battery Installation; Battery Installation and Warnings

5
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw,
and then open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AAA batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING
Adult assembly needed. Close the battery door and tighten
the screw to secure before giving your child the toy.
ATTENTION
L’assemblage doit être effectué par un adulte. Fermer puis
revisser fermement le couvercle du compartiment à piles
avant de donner ce jouet à un enfant.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.