Learning Resources Bullseye Compass - Page 2

Rotator
Quick Set™ Radius Indicator Radius Arm Metric Ruler
Protractor
Direct View™ Pivot Point Radius Holes US Standard Ruler
45°
45°
Learn more about our products
at LearningResources.com.
© Learning Resources, Inc., Vernon Hills, IL, US
Learning Resources Ltd., Bergen Way,
King's Lynn, Norfolk, PE30 2JG, UK
Please retain the package for future reference.
Made in China. LPK45701-BLSTR
US. Pat. #5615485; 6,606,796 and other patents pending.
45701
Bullseye
®
Compass
8
+
ages
grades 3+
Compass
Draw Circles -
Make an infinite number of perfect
circles from 24mm/1” diameter to
24cm/9.4” diameter.
1. Slide the Quick Set™ radius
indicator to desired position.
2. Mark the circle center by putting
a dot on your drawing surface and
place the Direct View™ compass
point over the dot.
3. While holding the rotator to the
surface, insert pen or pencil into the
desired radius hole and swing an arc
to form a circle.
Ruler
Draw and Measure Lines -
in inches or centimeters.
Produce Geometric Constructions
and Patterns - an unlimited
amount of constructions and
designs are possible!
Protractor
Construct and Measure Angles -
Use the 180° protractor with 5°
increments.
Construct an Angle -
Draw a base line. Place the Direct
View™ compass point on the base
line and rotate the radius arm until
the required angle is in line with the
baseline. Draw a line to complete
the angle.
Measure an Angle -
Use as a standard protractor.
C
M
Y
CM
MY
CY
CMY
K
45701 Bullseye Compass Blister NBR_HI.pdf 2 8/9/17 5:06 PM