Leatt 3.5 - Correct Fitment

Copyright © 2021, Leatt
®
Corporation
4
GB
Thesizeofthebraceshouldbecorrectforyourbodyshapeandallowforadjustabilitytoensurecorrecttment
and comfort. When correctly adjusted and worn with your helmet, the 3.5 neck brace should allow for a full safe
rangeofarider’sheadandneckmovements(i.e.lookingup,lookingdownandlookingside-to-side,suchas
whenperforminganover-the-shouldercheck);the 3.5 neck brace and the helmet must come into contact
with each other as the full safe range of normal riding head movement is reached. (5a)
If any resistance or discomfort is experienced when attempting to complete the full safe range of head and neck
movements, or if the brace does not make contact with the helmet when the full range of movement is reached,
further adjustment, or an alternative size of 3.5 neck brace may be required. In extreme circumstances, it may be
necessary to purchase an alternative model of helmet in order to achieve the required level of compatibility and
safety.
Ifthebraceinterfereswithanyoftheabovementioned,pleasemoveontotheadjustmentsection(p5).Pleaseask
the retailer or contact Leatt
®
ifyourequirefurtheradviceonsizing,adjustmentortting.
Check that you have the right helmet rim clearance. Please use assistance to do this measurement, do not do
it yourself. Place a ruler in the middle of the upper rim of the brace at 90
o
to the ground, with your head in a
neutral(level)position(5b).Remembertodofrontandback.Thehelmetrimshouldbewithinthezoneofoptimum
eectiveness(5c)
Please ensure that the brace wing tips are correctly aligned over your shoulder as shown below:
Correct tment
4
5
c.
b.
130mm
50mm
150mm
50mm
a.