LECTRICEBIKES.COM | 602.715.0907 14
Frame
To unfold:
1. To unfold the bike frame,
stand near the frame where
the terminals are exposed.
Grab the stem and rear end
of the bike. Lift the bike
slightly off the ground and
swing to the closed position.
2. Push down the latch rmly
until it locks into position.
3. The switch on the latch will
click into place to conrm it
is secured in place.
4. Pull on the latch to conrm
that the latch has locked and
that the frame cannot fold.
1
4
2
3
Folding Stem
To unfold:
1. Pull up the stem/ handlebars.
2. Make sure the stem is
completely set in place.
3. Push the lever rmly so that it
is locked in place. You should
have to use enough force
such that the clasp leaves an
imprint in your palm.
Pull on the clasp with your
hand to conrm it is locked
and the handlebars cannot
fold.
Folding and Unfolding Continued
1
3
2
To Next Page
Loading...