Replace Battery
Open the transmitter case by sliding the battery cover to expose the battery. Remove the
battery and disengage the polarized connector. Do not stress the wires by dangling the
battery while still connected. Replace the battery with the specified alkaline battery.
Replace the cover.
Setting User Code
The user code has already been set for your unit and, therefore, does not require
adjustment. However should it become necessary to change or reset the code, the
following should be observed.
The transmitter and receiver must have the identical User Code to communicate. The User
Code is a numerical representation of the switch settings. e.g. "123" indicates that switches
#1, #2, & #3 are in the "on" position, all other switches being "off". To set the transmitter
code, remove the battery to expose the switches.(see illustration) Using a pointed tool, or
even a golf tee, switch the appropriate switches to the "on" position.
To change the receiver code, to avoid conflict with another user for instance, the receiver
must be removed from the ‘Kaddy, opened to expose the set of switches and the switch
positions modified as described for the transmitter. Mark the new code on the receiver
enclosure for future reference. Reset the transmitter code as described above.
To Next Page
Loading...