STEP 7: While holding the screw and the rim with
one hand, insert flat washer, and lock washer from the
back of the unit, then hand tighten the acorn nut.
STEP 11: Fill the base until it overflows. Then, reinstall
the fill plug.
STEP 12: Loop the net, starting with the wider end of
the net.
STEP 8: Insert 3 screws (B) into remaining rim holes
and repeat Step 7. Using the allen wrench to hold the
screws in place, tighten the acorn nuts with the nut
driver.
STEP 9: Determine the final location for your new
Hoopstr. Gently tilt back to engage wheels. Exercise
caution when tilting and setting the unit back down.
STEP 10: Unscrew the fill plug. Use the plug key
if necessary.
Acorn
Nut
Screw B
Rim
Backboard
Lock
Washer
Flat
Washer
Rim
Allen Wrench Nut DriverBackboard
To Next Page
Loading...