Legacy Heating PH02-S - Connecting Post to Post Support; Securing Gas Cylinder; Connecting Regulator to Cylinder

ASSEMBLY INSTRUCTIONS
H
CYLINDER VALVE
PRESSURE
RELIEF VALVE
BLEED-OFF
VALVE
BLACK COUPLING NUT
REGULATOR
turn clockwise to connect
turn clockwise
to reseal
12. Turn the cylinder valve on the tank
clockwise to close the propane tank.
Attach the regulator (H) to the cylinder
valve by turning the regulator coupling
nut clockwise. Make sure it is fastened
securely and tighten connections by hand
only.
11. Place the 20 lb gas cylinder in the center of
the base, fasten it with the webbing (MM).
10. Remove the pre-assembled screws from the
post support (F) and attach post (D) to the post
support (F) using those 4 screws.
MM
Page 10
F
D
C