11
Mount Isolating Support Blocks
- Position the first of two support blocks as shown. (Figure 4)
- With a pencil, scribe a horizontal line onto the stud at a
distance 12.75” down from the top.
- Hold the top of the block even with the scribed line.
- Slide the block until it protrudes 0.75” beyond the outer wall.
- Insert one screw through block and into stud.
- Level block.
- Insert second screw through block and into stud.
- Using level, transfer another mark representing top of block to
opposite stud. (Figure 5)
- Install second block. (Figure 6)
- Check both blocks with level. (Figure 7)
Speaker Installation
To Next Page
Loading...
