STEP 2 - Place the Top Pole on the Ladder
Locate the top pole. Insert the pole through the top two holes of the ladder (1). Then align the
holes of the top pole with the holes of the ladder. Locate the 2 screws attached to the pole and
use the Phillips screwdriver to carefully tighten the two screws to fix the top pole to the ladder.
Put the rubber end (2).
(1)
(2)
STEP 3 - Put Black Knobs on Barrel
Locate the 4 black knobs. Use adjustable wrench to loosen and remove the 4 nuts at the bottom of
the barrel. Next, twist on the 4 black knobs to the bottom of the barrel where you removed the
nuts. Then adjust the distance of the ladder from the barrel by loosening the 4 black knobs and
evenly sliding the barrel away from the ladder.
To Next Page
Loading...
Need help?
General