Repeat symm at the front.
6.8.
1. Put a 1x1 button ver, upright, button to the right, into the bottom hole of each of the two PPs.
2. connect this part to your main structure, as is, from the front, putting the leftmost long connector (at the
bottom) of the main part (from the back) into the hole in the ribbed tube at the right of the part.
Put momentarily aside.
Bag 7
Put the spectacles piece (the wide double piece) on the table, on its side, the oculars one on top of the
other, from front to back, at the right. Insert a ridged Philips stick from the top into the top cross-hole (at
the left) – just a little.
Put the binocular piece symm from the left, the middle part in between the spectacles handles.
Push the stick all the way down.
Connect this part to your main structure, as is, from the front, inserting the long connector at the left, on
top, of the main structure (from the back) into the right bottom hole of your part.
Bag 8
Insert a long connector from the front, long end first, into the left top hole of the same part. Lay
momentarily aside.
Bag 9
Put a F 2x1 hor on the table. Put a F 2x1 with the hole underneath, hor, the hole to the left, on the left
button of the PP.
Put a 2x1 curve hor to the right, slide to the right.
Repeat steps 1-2 to make two such parts.
Put one, as is, from the front on the long connector from bag 8.
Put the other one symm from the back on the same connector.
Lay momentarily aside.
Bag 10.
Put a F 3x1 ver on the table.
Put three 1x1 wedge pieces on top, slides to the left.
Put this part ver, slides to the left, on the free buttons at front and back, of the two previous parts (to the
left of the curved pieces).
Check that this part is able to rise to the left.
To Next Page
Loading...
Need help?
General
