Number 1.
Put a F 10x4 hor on the table.
Put a F 4x1 ver to the right.
Number 2.
Connect by purring a F 10x2 hor on top, in the middle, starting
from the right.
Put a FS 4x1 ver on the left edge.
Put a F 2x1 hor on the front edge, on the third-fourth column
from the right.
Repeat symm at the back.
Skip two column to the left and put a F 2x1 hor there.
Repeat symm at the front.
Number 3.
Flip upside down, back to front.
Put a 2x2 ridged cylinder at the left edge, in the middle.
Repeat symm at the right.
Flip right side up and LMA.
Number 4. Make six identical parts.
Put a 4x2/2x1 piece hor on the table, the 2x1 side to the back.
Put a 2x1 ladder piece ver on the right edge, slide to the back.
Put a 2x1 ladder piece ver to the left, as before.
Repeat twice.
Repeat steps 1-4 five times to make six such parts.
Mount one. As is on the right end of the front edge.
Mount the other as is to the left.
Repeat.
Mount three other such parts symm at the back. Take a f2x2 with
wings and put it hor to the left of the fs2x1 wings to the right.
Put a fs2x2 in the space between the wings. Put a fs4x1 ver to
the right. Put as 4x4 with 4 buttons ver to the right, buttons to
the right, put a fs4x1 to the right.
To Next Page
Loading...
