11
Getting Started with LEGO
®
MINDSTORMS
®
Education EV3 MicroPython
Version 2.0.0
Figure 2.5: Configuring the USB connection between the computer and the EV3 Brick.
2.4 Downloading and running a program
Press the F5 key to run the program. Alternatively, you can start the program manually by going to the ‘debug’
tab and clicking the green ‘start’ arrow, as shown in Figure 2.6.
When the program starts, a pop-up toolbar allows you to stop the program if necessary. You can also stop the
program at any time by using the Back Button on the EV3 Brick.
If your program produces any output with the print command, this is shown in the output window.
Open the
‘file’ tab
Select your EV3 Brick
Connect your EV3 Brick using the USB cable
Open the device browser
Search for your EV3 Brick
1
5
2
3
4
LEGO, the LEGO logo and MINDSTORMS are trademarks of the LEGO Group.
©2019-2020 The LEGO Group.
To Next Page
Loading...
