LEGO MINDSTORMS Education EV3 - Page 9

7
Getting Started with LEGO
®
MINDSTORMS
®
Education EV3 MicroPython
Version 2.0.0
1.5.2 Viewing motor and sensor values
When you’re not running a program, you can use the device browser to view the motor and sensor values,
asshown in Figure 1.6.
1.5.3 Reverting to the original firmware
You can revert to the LEGO
®
firmware and your LEGO programs at any time. To do so:
1. Switch off the EV3 Brick as shown above.
2. Wait for the Display and Brick Status Light to switch off.
3. Remove the micro SD card.
4. Switch on the EV3 Brick.
Figure 1.6: Viewing motor and sensor values
Open devices
Choose device type
Watch values
1
2
3
LEGO, the LEGO logo and MINDSTORMS are trademarks of the LEGO Group.
©2019-2020 The LEGO Group.