front to the right, putting the clasps on the handle.
Repeat symm at the back.
16. Make two shooters by inserting the pegs into the long connectors and put hor, the pegs to the left, in
the attached tubes to the right of the wings.
17. Put two 2x1 lip pieces hor, upside down, lips to the right, in the recess in the middle of the left side.
18. Turn your structure the right side up.
Skip one column from the right and put a F 1x1 with a clasp ver on the back row, the clasp to the back.
Put a F three-button corner piece to the front and to the left, braille letter H.
19. Put two FS 1x1 wedges on the rightmost column, slides to the right.
Put a F 2x1 with one button ver to the left.
Repeat.
20. Put a F 2x1 with the clasp hor to the front and to the left, touching corners with the PP, the clasp to
the front.
Repeat symm at the back.
Put a F 2x1 ver to the left and to the front, touching corners with the PP.
21. Put a FS 4x1 receiver piece hor to the front and to the right.
Repeat symm at the back.
22. Put a F 2x1 with one button ver to the front of the leftmost column of the PP.
Put a F 2x1 with one button ver to the left (and 1/3 down).
Put a F 2x2 to the left.
23. Put a joystick piece on the rightmost button.
Put a FS 1x1 wedge to the left, slide to the right.
Skip one column to the left and put another wedge there, slide to the left.
Put another wedge to the left (and 1/3 down), slide to the left.
24. Insert a round end of a half-Philips connector from the left hor into the attached tube at the front on
the left.
Repeat symm at the back.
Put a S 2x2 loft piece upright, slide to the top, on the side buttons on the left edge.
25. Make a part. Stack two F 2x2 disks. Put a FS disk on top. (the flat smooth disks have a line down the
midle, to imitate an engine.
To Next Page
Loading...
