LEGRAND DX2 Series - Page 34

• Two RJ45 connectors - for connecon to the Sensor port of a supported managing device and•
chaining
• One PS - parcle/dust sensor device (SPS30)•
• One 150mm cable [EC350VM-04P] to [ZHR-05P] - for connecon of the DX2-PS to the SPS30•
▶
Parcle Sensor
• Reports dust density in µg/m^3•
• Detecon range: 1-1000 µg/m^3•
• Operang range: 0 - 60°C, 0 - 85% RH•
• Measures total dust density of categories PM1.0, PM2.5, PM4, PM10•
• By default lower crical and lower warning thresholds are deacvated•
• Upper crical threshold is set to: 100µg/m^3•
• Upper warning threshold is set to: 50µg/m^3•
Parculate Maer category Mass Concentraon Measurements of Parcles Accuracy
PM 10 0.3 to 10.0 µm ±25 μg/m3 @ 0 to 100 μg/m³
±25 % @ 100 to 1000 μg/m³
PM 4
0.3 to 4.0 µm Same as PM 10
PM 2.5
0.3 to 2.5 µm ±10 µg/m³ @ 0 to 100 µg/m³
±10 % @ 100 to 1000 µg/m³
PM 1.0 0.3 to 1.0 µm Same as PM 2.5
Note: Each higher category reading contains all parcles of the lower categories: PM10 >= PM4 >=
PM2.5 >= PM1.0.
34