LEGRAND LEXIC 037 09 - Starting; Complete reset; Selecting functions; Set actual time

set impulse time
Press once
Set
check the start
times previously
programmed
Press up to
14 times
Set
Press once
1 2 3 4 5 6 7
Set
Press once
1 2 3 4 5 6 7
1
1
Set
Press once
Set
Press once
Set
press or until desired minute is
shown
Press once if the start time for each
day is the same
END
or
choose other days with
or and
3.
Set
Set
Set
4.
1
sec
5.
1 2 3 4 5 6 7
1
1
Set
Set
6.
Start
1 2 3 4 5 6 7
Start
1 2 3 4 5 6 7
Start
1 2 3 4 5 6 7
Set
Set
Set
Set
7.
Start
1 2 3 4 5 6 7
8.
Set
Set
C
±1h
9.
10.
Test
1x
11.
C
Set
1.
2.
±1h
C
1 2 3 4 5 6 7
1
1
+
Press once
set time
program new start
time
return to actual
time
Press once
Press once
Press until
Press once
END
END
Press once
Press once
Press until the chosen start time is
shown
start time is deleted,
set a new start time or
return to actual time
Press once
Press once
END
Press once
Press once
press or until the correct minute
is shown
press or until the correct hour is
shown
press or until desired
time duration is shown
END
press or until desired hour is
shown
press or until the bar is shown at
the correct day
By pressing the button the various func-
tions can be selected “in turn“
3. Selecting functions
Set
4. Set actual time
+
—
+
—
+
—
1
sec
5. Set impulse time
1 2 3 4 5 6 7
1
1
—
Set
+
Set
Press until
Set
+
—
—
6. Set start time
Start
1 2 3 4 5 6 7
Start
1 2 3 4 5 6 7
Start
1 2 3 4 5 6 7
Set
Set
Set
Set
Set
+
—
+
7. Delete start times
Start
1 2 3 4 5 6 7
8. Summer/winter changeover
Press until the actual time advances
1 hour (summer) or goes back 1 hour
(winter).
Set
C
±1h
9. Manual control of impulse times
Press
With this operation the impulse cycle is
immediately manually controlled.
Attention !
This operation can lengthen a cycle or
can be lengthened by a program in
memory.
10. Test operation of a cycle
Press
Using this function a programmed
impulse cycle can be completely
testrun in approx 10 seconds.
Attention !
This function can also be used to pre-
maturely terminate a cycle already run-
ning.
Test
1x
11. Errors during programming
Press as often as required to return
to actual time.
C
1. Starting
It can take up to 3 minutes after connection
of the supply voltage before the symbols
appear on the LCD.
On first connection a complete reset operation
should be carried out.
2. Complete reset
push
together
The time switch is completely reset with all
memory functions deleted