1110
Thermostat with display
Installer manual
4 Configuration
4.1 Physical or advanced configuration
Depending on personal requirements and the type of system to install, the thermostat may be
configured in two ways: physical or advanced configuration.
The physical configuration is completed by connecting the configurators to the appropriate sock-
ets on the back of the thermostat.
If no physical configurators are connected, the device can be configured virtually by connecting it
to a PC and using the dedicated MyHOME_Suite software.
In this way it is possible to simplify the configuration operations in large systems, without the need
to manually intervene on each device.
The advanced configuration also gives the possibility to control several actuators with one single
thermostat, and to configure the automatic changeover mode (heating / cooling).
For the configuration see the product technical sheet.
To Next Page
Loading...
