3
before you start
Review this guide in its entirety before beginning device installation. Consult an
electrician with any questions or if you are unsure of your abilities.
DWarning: Incorrect installation could
result in death, serious injury, and/or
damage to your home or devices:
• For dry, indoor use only.
• Connect the smart remote switch to a
120 VAC, 60 Hz power source ONLY.
• The remote switch pairs ONLY with the
smart switch (WTRL10) and plug‑in
switch (WTP10) for multi‑location
control.
• The remote device does NOT connect to
any lighting loads. It is powered by your
electrical wiring and uses a wireless
connection to control its paired devices.
• Always use copper wire to install the
smart remote switch and follow all
applicable local and national electrical
codes.
• Install in a non‑metallic electrical box
to protect wireless signal strength.
Visit the Legrand website at www.legrand.us/radiant/smart‑lighting.aspx to learn more
about your device.
To Next Page
Loading...
