8
installation & setup
step two
|
remove the existing device
Check for the following wires:
1
HOT or LINE: Receives power from the circuit box. Referred to as “Hot” for the
purposes of this guide.
2
LOAD: Directs power to your light(s).
3
NEUTRAL: Creates a path to return current to the power source when the
device is off. Required for your switch installation.
4
GROUND: Provides a safe path for electricity in the event of a short circuit.
NOTE: Refer to “faqs” on page 23 if you are unsure of your wiring.
To Next Page
Loading...
