42
MESSAGE MEANING AND OPERATING ADVICE
Charge finished
Faulty functioning of the battery charger.
Contact the LEGRAND Technical Support Service.
Battery disconnected
or polarity inverted
The batteries were not connected correctly ot the polarity has been inverted
INFORMATIVE EVENTS (paragraph 5.4.4)
MESSAGE MEANING
User Turn ON User start-up of the UPS
User Turn OFF User shutdown of the UPS
Auto turn ON Automatic UPS start-up
Timed turn OFF
The UPS has been shut down via the delayed shutdown programming
(paragraph 5.4.2)
Stand-by battery charge start The battery charger has started in stand-by mode
UPS on battery The UPS has transferred to battery mode
UPS on mains The UPS has transferred to normal mode
Line Out turned OFF The output is not powered
Battery test executed Battery testing successfully completed
Battery learning executed Battery calibration successfully completed
Forced Bypass ON The forced bypass mode has been enabled
Forced Bypass OFF The forced bypass mode has been disabled
Maintenance Bypass ON The load is powered directly from the bypass line
Maintenance Bypass OFF
The load is no longer powered directly from the bypass line
Enter in Hot Swap The UPS has started-up the hot-swap mode
Exit From Hot Swap The UPS has exited the hot-swap mode
Event list erased The event list has been erased
Battery replaced The batteries have been replaced by the LEGRAND Technical Support Service
6. Diagnosis
To Next Page
Loading...
