Need help?Do you have a question about the LEGRAND VADDIO ConferenceSHOT ePTZ and is the answer not in the manual?
General| Sensor Type | CMOS |
|---|---|
| Resolution | 1920 x 1080 |
| Video Output | HDMI, USB 3.0 |
| Operating Temperature | 0°C to 40°C |
| Weight | 1.5 lbs |
| Camera Type | ePTZ |
| Effective Pixels | 2.1 Megapixel |
| Focus | Auto |
| White Balance | Auto |
| Exposure Control | Auto |
| Video Resolution | 1080p |
| Audio Input | 3.5mm Stereo Mini Jack |
| Connectivity | USB, HDMI |
| Control | RS-232 |
| Power Supply | 12V DC |
Lists the topics covered in the manual.
Highlights the key capabilities of the camera system.
Describes physical features visible on the camera's front.
Crucial warnings to prevent damage and maintain warranty validity.
Preparatory steps for a successful camera installation.
Guidance on selecting and using appropriate cables and connectors.
Addresses the default IP and its network implications.
Lists supported web browsers for accessing the interface.
Summarizes methods for initial device setup.
Setup process using the Vaddio Device Controller tablet.
Accessing the camera's web interface, including security warnings.
Final steps for completing initial device setup.
Details security settings like passwords and access.
Setting a static IP address to avoid conflicts.
Adjusting Auto-framing parameters for specific needs.
Principles of digital pan, tilt, and zoom operation.
How quickly the camera responds to new motion.
Minimum change recognized as motion.
Echo cancellation, master output, gain control.
Viewing the camera's USB stream with media players.
Settings for USB streaming and conferencing applications.
Viewing IP stream using a media player.
Setting up and storing static shots as presets.
Exporting and importing camera configuration.
Camera operation using the web interface.
Using zoom buttons for adjustment.
Moving to pre-programmed positions.
Muting audio and video streams.
Switching between standby and ready states.
Setting and storing shots with the remote.
Clearing stored presets with the remote.
Command to enable/disable Auto-Framing.
Command to move camera to home position.
Command to get/set audio volume.
Command to get network settings.
Command to enable/disable IP streaming.
Command to get firmware version.
Command to ping a host.
Command to retrieve command history.
Command to display CLI syntax.
Command to end Telnet session.
Troubleshooting for power and control issues.
To Next Page