LEGRAND Wattstopper LMCP48 - Panel Setup: Location, Date;Time

16
Display Description Press
Point to the desired
Panel IR Sensor and
press ‘Select’
Point the LMCT-100 at the infrared sensor on the
LMRD board and press Select.
Se
lect
Location Settings
Date and Time
Network
Button Binding
Panel Programming
Status
Panel Setup
This screen is the starting point for all following
instructions.
Setting the Panel Location
Setting the panel location provides sunrise/sunset information to the panel, for use when you set a schedule according to an
astronomical clock.
NOTE: The LMCT-100 has a limited number of locations to choose from. For a much more extensive list, use the LMCT-100 software to
access this feature.
Display Description Press
Location Settings
Date and Time
Network
Button Binding
Panel Programming
Status
Panel Setup
When you first enter the Panel Setup screen,
Location Settings is already highlighted.
Press Select.
Se
lect
Point to the desired
Panel IR Sensor and
press ‘Select’
Point the LMCT-100 at the infrared sensor on the
LMRD board and press Select.
Se
lect
Location Setup
DONE SEND
State: Rhode Island
City: Newport
Latitude: 41N
Longitude: 71W
Hours Behind GMT 5
Select the desired State, and City. The Latitude/
Longitude/Behind/Ahead Hours are fixed values.
Then highlight SEND and press Select.
Once again, point the LMCT-100 at the infrared
sensor on the LMRD board and press Select. You
return to the Location Setup screen.
Highlight DONE and press Select, or press to
return to the Panel Setup screen
then choose
SEND and
press Select
or
to move to each
parameter
or
to change the value
of the parameter
Setting the Date and Time
The date and time are used for schedules, including both manually set events and sunrise/sunset determination (in conjunction with the
location settings).
Display Description Press
Location Settings
Date and Time
Network
Button Binding
Panel Programming
Status
Panel Setup
From Panel Setup, scroll to Date and Time. Press
Select.
then
Select