LEGRAND Wattstopper LMCP48 - Group Setup and Configuration

23
Display Description Press
Mon: <Y> Tue: <Y>
Wed: <Y> Thu: <Y>
Fri: <Y> Sat: <N>
Sun: <N> Holiday: <N>
D/L Event Active On
DONE
Once you have set the parameters on the Dark/
Light Event x screen, highlight ACTIVE DAYS and
press Select.
For each day of the week, select whether the dark/
light event will be active (Yes or No). Additionally,
select whether the event will be active on holidays.
(You determine which days are holidays in the
Holidays screen.)
Highlight DONE and press Select to return to the
Dark/Light Event x screen. Then select DONE
again to return to the Dark/Light Events screen.
then choose
DONE and
press Select
or
to move to each
parameter
or
to change the value
of the parameter
Event: <1>
Dark/Light Events
NEXT DONE DELETE SEND
Highlight SEND and press Select.
Once again, point the LMCT-100 at the infrared
sensor on the LMRD board and press Select. You
return to the Dark/Light Events screen, where you
can program the next event
When finished, highlight DONE and press Select to
return to the Panel Programming screen.
to choose
SEND and
press Select
or
Groups
On this set of screens, you assign loads to groups and customize the behavior of those groups.
Display Description Press
603981210
Schedules
Holidays
Dark/Light
Groups
Occupancy Sensors
Panel Programming
From the Panel Programming screen, highlight
Groups and press Select.
then
Select
Point to the desired
Panel IR Sensor and
press ‘Select’
Point the LMCT-100 at the infrared sensor on the
LMRD board and press Select to open the Group
Setup screen.
Se
lect
Group: <1>
Type: <SensAutomatic>
Group Setup
LOADS CUSTOM
DONE DELETE SEND
Select the Group number. In the Type field, select
one of the predefined macros or select “Custom” to
define the group behavior parameters. For details,
see Macros on page 7. Next, highlight LOADS and
press Select.
Once again, point the LMCT-100 at the infrared
sensor on the LMRD board and press Select to
open the Group x Loads screen.
then choose
LOADS and
press Select
or
to move to each
parameter
or
to change the value
of the parameter
Group 1 Loads
DONE SMARTWIRE
Load: <1>
Member: <Yes>
To assign various loads to the group, scroll through
each Load number and select whether that load
is a Member of that group. When complete, select
DONE to return to the Group Setup screen.
You also select have the option of using the
Smartwire function instead of manually scrolling
through the loads. To do this, select SMARTWIRE
then choose
DONE and
press Select
or
to move to each
parameter
or
to change the value
of the parameter
OR
Select SMARTWIRE
Point to any IR
enabled device and
press Select to
begin Smartwiring
loads within the
Panel
Point the LMCT-100 at the infrared sensor on the
LMRD board and press Select
Se
lect