LEGRAND Wattstopper LMCP48 - Page 28

28
Display Description Press
Load 5 Parms Not Same
01 11.0 1 . . . . . 10
11 11. . . . . . .1 20
21 . . 101. . . . . 30
31 . . . . . . . . . . 40
41 . . . . . . . . . . 50
51 . . . . . . . . . . 60
Group 1 Status Mixed
This screen indicates which loads are assigned
to the group, along with the on/off status of each
load. A value of “1” indicates it is ON. A value of “0”
indicates it is OFF. A value of “.” indicates the load
is not assigned to the group.
On the top line, the Status will display “Off” if all
assigned loads are off, “100%” if all loads are on
and there is no dimming, and “Mixed” if some loads
are on and others are off. If all loads in the group
dim and are set to the same dimming amount, it
will display that amount.
Move the cursor to highlight a specific load. If you
scroll down below the line for 51–60, you will see
loads 61–64.
The load number will display in the second line.
The Parms parameter will say either “Same” if
the load parameters match the group parameters,
or “Not Same” if there is a difference. To view the
difference, press Select to open the Actual Load x
Parms 1 screen
then press
Select
or
or
to select the
desired load
Blink: 5 min
TDelay NH: None
TDelay AH: 120 min
NH–>AH: Turn Off
AH–>NH: Turn On
Actual Load 5 Parms1
MORE GROUP PARMS DONE
The screen displays the values of the first five
parameters assigned to the individual load.
To view the sensor parameters, highlight MORE
and press Select.
To compare the values on this screen with the
values for the group, highlight GROUP PARMS
and press Select.
then press
Select
or
to choose the
option
Sensor Behavior
AH: Man On/Auto Off
NH: Auto On/Off
Actual Load 5 Parms2
MORE GROUP PARMS DONE
The screen displays the values of the sensor
parameters assigned to the individual load.
To return to the original 5 parameters, highlight
MORE and press Select.
To compare the values on this screen with the
values for the group, highlight GROUP PARMS
and press Select.
then press
Select
or
to choose the
option
Blink: 10 min
TDelay NH: None
TDelay AH: 120 min
NH–>AH: Turn Off
AH–>NH: Turn On
Group Load 5 Parms1
MORE LOAD PARMS DONE
The screen displays the values of the first five
parameters assigned to the group.
In this example, if you compare the Blink
parameter to the one on the Actual Load screen,
you will see the group value is 10 minutes, while
the individual load is 5 minutes.
To view the sensor parameters, highlight MORE
and press Select.
To compare the values on this screen with the
values for the individual load, highlight LOAD
PARMS and press Select.
then press
Select
or
to choose the
option
Sensor Behavior
AH: Man On/Auto Off
NH: Auto On/Off
Group Load 5 Parms2
MORE LOAD PARMS DONE
The screen displays the values of the sensor
parameters assigned to the individual load.
To return to the original 5 parameters, highlight
MORE and press Select.
To compare the values on this screen with the
values for the group, highlight GROUP PARMS
and press Select.
Once you finish comparing the values, highlight
DONE and press Select to return to the Status
screen
then press
Select
or
to choose the
option