LEGRAND Wattstopper LMCP48 - Light Level; Occupancy Sensor Status

29
Light Level
This screen displays the current light level, in foot candles, registered by an LMIO-301 with an attached photosensor.
Display Description Press
Light Level: 1 fc
301 1 of 2 Level
MAC: 0373303229
NEXT PRIOR DONE
The top line of the display shows the number of
LMIO-301s connected to the network. The display
shows the light level of a single device. The second
line shows the serial number (MAC address) of the
currently displayed device.
Highlight NEXT and press Select to view the light
level of another photosensor. Or select DONE to
return to the Status screen.
Se
lect NEXT
OR
Se
lect DONE
Occupancy Sensor Status
This screen display current values of occupancy sensors attached to the network.
Display Description Press
Status: Online
State: Occupied
Load Tra cking: Yes
OccSen 1 of 4 Stat
MAC: 0209715204
NEXT PRIOR DONE
The top line of the display shows the number of
occupancy sensors connected to the network. The
display shows the values for a single occupancy
sensor. The second line shows the serial number
(MAC address) of the currently displayed device.
Status indicates whether the sensor is currently
found on the network. (When a sensor is
connected, it is stored in memory until the panel
is reset. So, if the sensor is disconnected and the
panel has not been reset, the status will display
“Offline”.)
State indicates whether the sensor currently is set
as occupied or unoccupied.
If Load Tracking is “Yes”, loads bound to the
sensor will respond, based on the programming
settings for the sensor and group. If it is set to “no,
then the loads will not respond to the sensor. This
is used in situations where the panel is connected
to a BAS or other BACnet device and you want to
use the sensor to monitor occupancy/vacancy for
purposes other than turning loads on or off.
Highlight NEXT and press select to view the values
of additional photosensors. Or select DONE to
return to the Status screen.
Se
lect NEXT
OR
Se
lect DONE