2009-2013 FLH RENEGADE
General Safety Information
This kit is designed to be installed by a competent technician. Improper installation can affect
the safe operation of your trike, which could also result in serious injury or death. Make sure
you have a complete understanding of the work to be preformed. Unqualified installers are
urged to have the unit installed by a trained technician.
• Always protect yourself when the vehicle is in the air. Make sure the vehicle is properly supported
anytime you use a hoist or jack.
• Always use the proper tools.
• Protect your eyes by using proper safety glasses or goggles.
• Read through the installation instructions before you begin. Make sure you have all the proper
tools, parts and skill set to perform the installation safely and completely.
NOTE: Compliance with national (DOT-USA, MOT-Canada), State, Provincial, and local vehicle is
standards is the responsibility of the installer. Installation of the parking brake and grab han-
dles is necessary to achieve compliance with DOT/MOT.
ARB Label Confirmation– California Kits
1. See Fig. 1. California Air Resource Board (ARB) certification label must be affixed on all swin-
garms for kits sold into California.
2. Label should be placed on left side of swingarm 1/2” from rear
weld.
3. Make sure label correlates with correct model year.
GENERAL INFORMATION
5
Fig. 1