• Press the disconnect button on the trigger gun and pull the high-pressure hose out of the
trigger gun.
• Place the trigger gun in the trigger gun storage compartment.
• Place both spray lances into the appropriate container.
• Lance: Nozzle in downward direction.
• Coil the high-pressure hose and hang it over the hose storage compartment.
• Store the power connection in the accessory storage area.
• Before extended periods of storage, as in winter, also follow the instructions for maintaining
the unit.
• Always keep the unit, parts and accessories out of reach of children. The ideal storage
temperature is between 10°C and 30°C. Store the pressure washer indoors to prevent the
water inside from freezing and increasing in volume at temperatures below 0°C.
• We recommend using the original packaging for storage or covering the device with a suitable
cloth or cover to protect it from dust.
Frost protection
NOTE
Appliances and accessories that have not been completely dehumidified can be damaged in
cold temperatures.
Remove water completely from the unit and accessories. This will protect the unit and
accessories from freezing water. To avoid damage:
• Disconnect the device from the water source.
• Disconnect the spray lance from the trigger gun.
• Turn on the device.
• Depress the trigger gun lever and wait until water stops coming out of the nozzle.
• Release the trigger gun lever.
• Lock the trigger gun lever.
• Turn off the device.
• Store the unit and all accessories in a room protected from cold temperatures.
Maintenance
WARNING
Risk of electric shock
Before any work is done on the unit, it must be turned off and disconnected from the
power supply.
High-pressure hose
The high pressure hose is specially constructed with reinforced walls. Improper use can lead
to easy damage. It must therefore be stored properly.
• Do not twist the hose.
• Do not allow vehicles to drive over the hose.
• Do not place the hose near sharp edges. Improper use will lead to premature wear of the
hose and void the warranty.
Cleaning the sieve in the water connection
Regularly clean the strainer in the water connection.
To Next Page
Loading...