114
The synchronisation is selected on the flash units
with the corresponding features. For more details,
refer to the relevant instructions.
Important!
For synchronisation on the 2nd shutter curtain,
for high speed synchronisation, and strobe flash
techniques, the camera must be activated before
exposure, i.e. the exposure metering results must
be displayed. This ensures that the necessary
exchange of data between the camera and the
flash unit can take place. It is no
t enough to
simply place the camera in standby mode with
the main switch. If the camera was not activated,
these flash modes can function incorrectly (e.g.
no triggering or full flash instead of strobe
function).
For the same reason, these flash modes should
not be used in conjunction with rapid sequences
of shots in series exposures with motor drives/
winders.
To Next Page
Loading...
