Need help?Do you have a question about the Leixen UV-52 and is the answer not in the manual?
General| Output Power | 5W / 10W |
|---|---|
| Modulation | FM |
| Operating Voltage | 7.4V DC |
| Channel Spacing | 25kHz / 12.5kHz |
| Display | LCD |
| Waterproof | No |
| Frequency Range | 136-174 MHz, 400-480 MHz |
| Channel Capacity | 128 |
| Battery | Li-ion |
| Antenna Impedance | 50Ω |
Lists all components provided in the transceiver package.
Lists additional accessories that can be purchased separately.
Step-by-step guide for charging the battery pack to ensure optimal performance and longevity.
Specifies the correct battery model and outlines important safety warnings for battery usage.
Identifies and explains the function of each physical part of the transceiver.
Details the functions of primary keys like PTTA, PTTB, MENU, and EXIT.
Describes the use of numeric keys for data input such as frequencies and menu selections.
Illustrates key combinations used for special functions during transceiver startup.
Details the display of memory channels and status indicators for Channel A and B.
Explains icons representing functions like CT, Scrambler, Reverse, and VOX.
Instructions for powering the transceiver on and controlling the audio output level.
Methods for choosing operating frequencies in VFO mode and channels in MR/CH mode.
Covers the correct procedures for transmitting and receiving, including power management.
Details how to set the Auto Power Off timer to conserve battery life during inactivity.
Explains configuration options for DTMF signaling and simultaneous monitoring of two frequencies.
Guides on setting decode/encode types (CTCSS/DCS) for squelch control and communication.
Steps to activate or deactivate DTMF signaling on a per-channel basis.
Guidance on setting up and using individual and group call functionalities via DTMF codes.
Options to enable or disable the display of custom names assigned to channels.
Step-by-step process for creating and editing alphanumeric labels for channels.
Explains the programming capabilities of PC and PE keys for personalized shortcuts.
How to set PTT ID options and select transmission methods (start, end, or both).
Instructions for defining the frequency offset amount and direction for repeater use.
Explanation of Time Operated (TO) and Carrier Operated (CO) scan modes.
How to select scan frequency ranges and perform scans in different operating modes.
Procedures for setting the squelch sensitivity levels for both Channel A and Channel B.
Settings for minimizing noise burst at transmission end and enabling same-frequency operation.
How to set a timer to limit transmission duration and prevent accidental long transmissions.
Explains how the TX Stop feature prevents unauthorized transmissions.
Configuration of VOX delay and sensitivity for hands-free voice-activated transmission.
How to choose between Wide and Narrow bandwidth settings based on regulations.
Resets all transceiver settings, including memory channels, to factory defaults.
Resets specific functions to factory defaults while retaining memory channels and DTMF data.
Deletes the currently active channel from the transceiver's memory.
Instructions for setting a password to protect transceiver programming via software.
Explains how to limit transceiver usage duration and its behavior after lease expiration.
Information on factory calibration, testing, and the impact of user maintenance on warranty.
Recommended steps for cleaning and maintaining the transceiver to ensure optimal performance.
To Next Page
