EN-10
- Check whether all rotor segments have been locked (A, B, C,
fig. 6).
- Use all lighting and warning signals required by law (or
other regulations prescribed by the authorities).
- For transport on public roads, ensure that the front axle
weight is sufficient (fit front weights, if necessary) and
that the permitted maximum rear axle weight is not ex-
ceeded.
The machine is now ready for transport.
Never allow the PTO shaft to rotate when the machine is in
the transport position.
4 MACHINE ADJUSTMENTS
Ensure that no-one is near the machine when it is switched
from the transport position to the working position.
Put the machine into the working position as follows:
• Pressurise the pressure line of the control block.
Switch the valve or change the insert nipples of the hydraulic
hoses if the hydraulic system does not function in case of any of
the following operations.
• Using handle c (fig. 5), release the arms from the locking sys-
tem.
• Using handle d, turn the arms of the lateral rotors outwards.
• Using handle e, fold out the outer rotor segments and the four
rear rotor segments.
• Using handle c, lower all rotor segments to the ground. The in-
termediate frame will tilt forwards.
• Depressurise the pressure line of the control block.
To Next Page
Loading...
