EN-10
3 TRANSPORT
The LOTUS tedder can be transported in the tractor hydraulics.
- Secure the STABILO steering device with the locking pin (fig. 5).
- Adjust the tines of the two inner rotors inwards (fig. 6).
- Fold up the lateral rotors using the tractor hydraulics.
- Block the hydraulic system by adjusting the tractor valve to the
blocked position.
- Check whether the ram has been secured by the locking hook
(fig. 7).
- Adjust the wheel supports of the lateral rotors to the position in
which the wheels protrude as little as possible (fig. 6).
- Lift the machine off the ground.
- Use all lighting and warning signals required by law (or
other regulations prescribed by the authorities).
- For transport on public roads, ensure that the front axle
weight is sufficient (fit front weights, if necessary) and
that the permitted maximum rear axle weight is not ex-
ceeded.
The machine is now ready for transport.
Never allow the PTO shaft to rotate when the machine is in
the transport position.
To Next Page
Loading...
