EN-14
6 DISMOUNTING FROM THE TRACTOR
- Lock the STABILO steering device (fig. 14).
The machine can be stored in two positions; either folded out or
folded up. The folded out position is recommended.
Always place the machine on hard, even ground.
- Storage in folded-out position:
• Adjust all wheel supports in the same position.
• Lower the machine to the ground.
• Use the hydraulic valve to gently lower the lateral rotor seg-
ments.
• Lower the machine onto the ground using the tractor hydrau-
lics.
- Storage in folded-up position:
• Adjust the wheel supports of the middle two rotor segments in
the closest position to the dish (fig. 15). This ensures the most
stable position for the machine.
• Lower the machine onto the ground using the tractor hydrau-
lics.
All other actions for dismounting the machine from the tractor are
identical in both cases.
- Switch off the tractor engine.
- Disengage the PTO shaft from the tractor PTO.
- Place the PTO shaft in the hook (fig. 16).
- Depressurize the hydraulic system and disconnect the hydraulic
hose. Slide the dust cap onto the plug.
- Remove the control cord for the locking hook from the tractor
cab.
- Place the two parking jacks of the headstock in the lowest posi-
tion.
- Screw in the top link until the parking jacks are on ground level.
- Adjust the rear parking jack in the lowest possible position
(fig. 16).
- Disconnect the top link from the machine.
- Disconnect the lower arms from the machine.
To Next Page
Loading...
