innovators in agriculture
EN-22
Assemble the cutter bar in the reverse order. Bear the following
points in mind while doing so:
- Clean the centring rings (10) and the contact areas of the mower
elements and intermediate spacers.
- Ensure there is no dirt between elements and spacers that were
not dismounted (rub the sides with Castrol Tarp).
- Grease the drive shaft (Molykote BR2 Plus).
Ensure that the mower discs are turned 90° in relation to one
another. If a unit cannot be slid onto the drive shaft in one
go, its disc must be turned by one or several half turns until
the unit can be placed.
- Fit the elements with the direction of rotation in the standard
configuration (fig. A-2).
•A RHrotation SPLENDIMO FC mower element can be identified
as follows:
When the hub is turned clockwise (R: fig. A-3), the drive gear
on the RH side (viewed from the rear) will turn anti-clockwise.
•A LHrotation element can be identified as follows:
When the hub is turned anti-clockwise (L: fig. A-3), the drive
gear on the RH side will turn anti-clockwise.
- After a mower disc has been removed, check whether the O-ring
(11, fig. A-1) is in the pressure piece.
- Tighten the castellated nut with a torque of 150-250 Nm (15-25
kgm) and secure it with a split pin. Ensure that the split pin does
not protrude above the pressure piece.
N.B. the nut may not be turned back; keep turning it until the split
pin can be fitted.
- The securing disc (13) and supporting ring have to be fitted in the
outer mowing element. If this element is replaced, these parts
need to be transferred to the new unit.
- First, tighten the 5 bolts (14) by hand.
- Grease the ring (8) as well as the threaded part of the connecting
rod (3) and nut (7) with Molykote P74. Fit the nut on the rod.
- Tighten the nut (7).
Torque: 950 Nm (95 kgm).
To obtain this torque, extend the wrench with a 150-cm long pipe
(fig. A-4) and then apply a force of 635 N (63.5 kg).
When fitting the securing plate, the nut should only be tightened
and not allowed to be unscrewed.
- Tighten the five bolts (14) with a torque of 120 Nm (12 kgm) and
secure the bolt with a second nut.
A-2
SPLENDIMO 280 FC
SPLENDIMO 320 FC
A-4
635 N
63.5 kg
950 Nm
(95 kgm)
Supplement A
To Next Page
Loading...
