innovators in agriculture
EN-23
A.2 Replacement of the disc on a drive
element
- Remove the three bolts from the cover A (fig. A-5).
- Remove the bolts from the protection bush B and lower it into the
hat C.
- Dismount the yoke D from the stub axle.
- Remove the cover A and protection bush B.
- Remove the four bolts in the bottom of the hat C and remove the
hat.
- Dismount the mower disc.
- Mount the parts in the reverse order. Pay attention to the position
of the disc in relation to other discs.
- Secure the mower disc bolts with Loctite 243. Tighten the nuts
with a torque of 20-25 Nm (2-2.5 kgm).
Supplement A
To Next Page
Loading...
