7
WARNING! Do not expose the chair to an excessively humid environment. If the chair
gets wet, remove the plug from the outlet and have it checked by an Authorized Service
Centre.
3. ENVIRONMENTAL WORKING CONDITIONS AND STORAGE
2.8. Instrucons to replace fuse
WARNING! It is strongly recommended to insert the plug into a single outlet exclusively
reserved to the device. We do not recommend the use of mulple sockets (power strip),
adopters and patch cords. The cable must not be bent.
WARNING! Before plugging in the cable, make sure that it is not twisted or bended and
make sure that the protecve sheath is undamaged.
WARNING! The chair must be posioned in order to ease the removal of the electric
plug.
WARNING! To avoid the risk of electrical shock, this chair must exclusively be plugged in
power supply grids with protecve ground.
WORKING CONDITIONS: WARNING! The chair was not conceived to be used in sengs with
explosive atmospheres, in presence of thin powders or corrosive gases, acids, corrosive agents
or salt.
Neither it is recommended to use the chair in presence of ionizing and not ionizing radiaons (x
rays, lasers, microwaves, ultraviolet rays).
- Not intended to be used in oxygen rich environments.
- Not intended to be used with ammable anesthecs or in conjuncon with ammable agents.
STORAGE! For the correct funconing of the electrical equipment the storage of the chair must
be at a temperature between -25° C and +55° C, and only for short periods not exceeding 24
hours, to +70°C. The chair has no special requirements for storage, provided that it takes place
in a closed and dry rooms; this condion should also be ensured during all phases of transport.
%
To Next Page
Loading...