8
lowered position must not release the quick coupling by themselves.
• Never leave the driver's seat whilst in motion!
• Handling behaviour, steerability and braking are influenced by mounted
implements, trailers and ballast weights. Check for sufficient steerability and
braking!
• When driving round bends note the width of the machine and/or changing
centre of gravity of the implement.
• Put implement into operation only when all guards are fixed in position!
• Never stay or allow anyone to stay within the operating area!
• Never stay in the turning and slew area of the implement!
• Do not operate any hydraulic controls while anybody is in the operating area!
• On all pivoting parts actuated by power assistance (e.g. hydraulics) exists
danger of injury by bruising and crushing!
• Before leaving the tractor lower the machine to the ground. Apply the parking
brake, stop the engine and remove the ignition key!
• Do not allow anybody between the tractor and implement if the parking brakes
are not applied!
• Swing attachment arm to transport position and secure!
Trailed implements
• Secure machine and tractor against unintended rolling away!
• Never exceed the maximum permissible load of the drawbar or hitch!
• When fitting the implement to a drawbar or hitch, ensure sufficient movement
at the hitch-point!
To Next Page
Loading...