If you have any

questions or

require customer

assistance, please

at (800) 444-5366.

LEMO USA, Inc.

635 Park Court, Rohnert Park, CA 94928

P.O. Box 2408, Rohnert Park, CA 94927-2408

(800) 444-5366 • (707) 578-8811 • fax: (707) 578-0869

www.LEMOusa.com • e-mail: info@lemousa.com

1. Strip the cable according to the dimensions

indicated in the table on page 3. For connectors

with solder contacts, the length L should be

reduced to correspond with interior contact

lengths.

●

7 7

Solder

2. Slide the following onto the cable: bend relief if

provided, collet nut ➀, collet ➁, metal washer ➂

flexible gasket ➃, and earthing cone ➄. In the

case of a shielded cable, fold back the shielding

around the whole circumference of the earthing

cone.

3. Slide the elbow inner shell ➆ onto the cable as

shown. Arrange together the collet ➁, washer ➂,

gasket ➃ and earthing cone ➄ over the cable.

Verifying that the shield remains around the

earthing cone circumference, cut off any surplus.

Verify also that the cable jacket remains correctly

located under the flexible gasket. Fit the collet

subassembly into the elbow inner shell ➆. Screw

on the collet nut ➀ respecting the tightening

torque (table on page 3). Fix the bend relief - if

provided - onto the collet nut.

K Series - Crimp/Solder Contacts - Elbow Plugs (90º)

4. For solder contacts, solder the conductors to the

contacts, making sure that the insulator ➇ and the

cable remain clean.

Lemo K Series - Assembly Instructions Manual

Other manuals for Lemo K Series