3. Your mobile device should show “Lenco BMC-080” in Bluetooth
Devices list, and then select it for pairing. Waiting for some seconds
and you will see connected message as shown on your mobile device.
(For some Bluetooth devices, you may need to input “0000” as
pairing password)
4. If pairing is successful, a beep sound will heard.
5. Now, you can start to sing or play music from your mobile device by
its music player program.
6. To power OFF the microphone, short press the “ (8)” button.
Note: For saving battery energy, the device will turn to off mode
automatically when no device is in paired in 8 minutes.
E. Disconnect from paired device
1. To disconnect with paired device, for better result turn off the device
directly. Or;
2. You can choose “Disconnect” from Bluetooth paired device list or
turn “Off” the Bluetooth function on your mobile device.
3. In this case the device will switch back to “Searching/Pairing” mode
automatically itself, a series of tones will sound.
4. Now, you can process for new mobile device pair or power off the
device as you wanted. (refer to item D.2 ~ D.5 methods mentioned
above)
F. Auto re-connect with paired device and New pairing
1. Every time you turn on the device’s power; it will firstly searching for
the mobile device, which has paired previously and still in record. The
device will re-connect this mobile device as priority if it is in
Bluetooth searching device mode and connection range.
2. If not found in some seconds, the device then will turn into new
pairing mode internally.
3. Now you can process for new mobile device pair. (refer to item
D.2~D.5 methods mentioned above)
G. Switch to new pairing from connected mode
1. In Bluetooth connected mode, you can switch the device into
Bluetooth searching/pairing mode for paring with new device at any
time you desired;
2. Press and hold the “ (8)” button until a series of tones sound.
3. Now you can process for new mobile device pair. (refer to item
D.2~D.5 methods mentioned above)
To Next Page
Loading...
Need help?
General
