NOTE: In order to achieve the best sound, it is advised to set the
turntable volume to a minimal level. Then the turntable's audio will be
played back through your own amplifier, speakers, etc.
1. Setting pre-amplifier selector switch
This product has a built-in phono amplifier function. You can use
the product even if you do not have a phono amplifier or
connectable equipment with a built-in phono amplifier.
Use the pre-amplifier selector switch to set the output, as shown
below.
Connectable equipment
being used
Position of pre-amplifier
selector switch
Where to connect RCA
audio cable
Phono input jack and
ground (earth) terminal of
connectable equipment
Device without phono
input
AUX or line input jack of
connectable equipment
NOTE: The RCA Jacks are not designed to be connected directly to the
passive/unpowered speakers on LINE mode. If connected to the
passive speakers, there will be no sound.
To Next Page
Loading...
