LENCO LS-500 - Troubleshooting; Common Issues and Solutions

- 10 -
Needle: AT-3600L
Frequency Response
20Hz - 20kHz
Channel Balance
<2.5dB
Channel Separation
>18dB
Output Voltage
2.5mV
Recommended Load Resistance
47kΩ
Amplifier connection
MM - input
Recommended Tracking Pressure
3.0±0.5g
Weight
5g
Note:
• Design and specifications are subject to change without notice.
Power supply adaptor:
Manufacturer: Brightpower Optoelectronic Technonlgy Co., Ltd.
Model Number: SW1502400-I02
Use only the power supply listed in the user instructions
Turntable Maintenance
1. Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the turntable mat or a record’s
edge.
2. Clean the stylus frequently with a soft brush with a back-to-front motion only.
3. Clean the records to get rid of dust or grease with a record cleaning brush and record cleaning solution.
4. Clean the turntable lid and turntable cabinet with a slightly damped microfiber cloth.
Note: Do not use cleanser other that contains alcohol,benzene or any other harsh chemicals, with might damage
the paint and finish of the turntable.
Troubleshooting
There is no power
• Power adaptor is not connected correctly.
• No power at the power outlet.
Power is on, but the platter does not turn
• This unit is not in turntable mode. Press the MODE button to turntable mode, the indicator light in red.
• Need to press the PLAY/STOP button once to start playing.
• Turntable’s drive belt is not installed or has slipped off.
Turntable is spinning, but there is no sound, or sound not loud enough
• Stylus protector is still on.
• Tone arm is lift up by the lever.
• The Phono/Line switch is set at PHONO position but RCA jacks connected to the stereo system’s line input.
• Forget to connect the speaker to the turntable.